Start machine
9.3.2 Fodder discharge via discharge conveyor for side discharge
Fig. 77
. Make sure that people leave the hazardous
area of the machine.
. Keep animals away from the hazardous
area.
3. Swivel the discharge conveyor (1) to
working position.
4
5
69
6
7
8
. Switch on the p.t.o. shaft.
. Switch on the discharge conveyor drive.
Observe the information in the chapter
"Discharge conveyor for side discharge"
page .
. Power the mixing auger at the desired
driving speed.
. Open the discharge door (2) at the desired
opening width. The set opening width of the
discharge door is indicated by the pointer
(3) on the scale (4).
. Travel over the feeding table at the desired
travelling speed.
The discharge conveyor speed is
infinitely adjustable in order to vary the
lateral delivery distance (throwing
range) of the fodder next to the fodder
mixing trailer. Observe the information
in the chapter "Setting of conveyor
speed for crossover conveyor /
discharge conveyor for side
discharge", page 73.
9
9
9
9
10
1
2
. Finish fodder discharge:
.1 Close the discharge door.
.2 Switch off the p.t.o. shaft.
.3 Switch off the discharge conveyor only
when the fodder discharge has been
finished.
. Swivel the discharge conveyor to transport
position.
Verti Mix Double K Edition
147
08.08
To Next Page
Loading...
