Safety instructions
Verti Mix Double K Edition
35
08.08
• Move the support devices into the supporting position (static
stability) when hitching up and unhitching the machine!
• Injury resulting from being crushed and cut can occur when
support devices are being applied!
• Be particularly careful when hitching and unhitching the machine
to or from the tractor! At the coupling points between tractor and
machine there is a risk of being crushed or cut!
• Is forbidden to go between the tractor and the machine when the
three point linkage is activated!
• Check coupled supply lines. Linked supply lines:
ο must easily follow every movement when cornering without
tension, bending or friction,
ο must not rub against external parts!
• Always park the unhitched machine on stable ground!
Using the machine
• Before starting work familiarize yourself with all the fittings and
operating elements on the machine as well as their functions!
During operation is too late.
• Wear tight-fitting clothes! Loose-fitting clothes increase the risk
of getting caught and wound up in drive shafts!
• Only start up the machine when all the guards have been fitted
and set in their protecting positions!
• Observe the regulations on maximum payload of the attached /
hitched up machine and the permissible axle and tongue loads
of the tractor! If necessary drive with the loading area only part-
filled.
• It is forbidden to stand:
ο in the work / danger area of the machine,
ο in the ejection range of the machine,
ο in the rotating and swivelling range of the moving parts of
the machine,
ο under raised and unsecured moving machine parts!
• On externally-powered (e.g. hydraulic) moving machine parts
there is a risk of being crushed and cut at certain points!
• Before activating externally-powered machine parts, ensure that
there is no-one in the danger area of the machine!
• Before leaving the tractor, secure it against accidental starting
and rolling away!
• Prop up opened covers securely before going under the covers!
To Next Page
Loading...
