Black plate (123,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
– When the battery of the access key
is discharged
– When the access key is in a
location with strong radio waves or
noise (e.g., near a radio tower, power
plant, broadcast station or an area
where wireless equipment is used)
– While talking on a cell phone
In such a case, perform the procedure
described in “Locking and unlocking”
F9-28.
. When an access key is in the operating
range, if the door handle becomes wet
due to exposure to a significant amount of
water when the vehicle is washed or
dur ing heavy rain, the doors may be
locked or unlocked.
! How to use keyless access func-
tions
! Keyless access function tips
. Turn off the push-button ignition switch
before locking the doors (including rear
gate) using the keyless access function. It
is not possible to lock the doors (including
the rear gate) using the keyless access
function when the push-button ignition
switch is on the “ACC” or “ON” position.
For details about turning off the push-
button ignition switch, refer to “Switching
power status” F3-7.
. When performing the locking proce-
dure too quickly, locking may not have
been completed. After performing the
locking procedure, it is recommended to
pull the REAR door handle to confirm that
the doors have been locked.
. It is not possible to lock the doors and
the rear gate when one of the doors or the
rear gate is open. Close all of the doors
including the rear gate and lock the doors.
. If the door handle is gripped with a
gloved hand, the door lock may not be
released.
. Within 3 seconds after locking the
doors and the rear gate by using the
keyless access function, it is not possible
to unlock doors and/or the rear gate
(Outback) by using the keyless access
function.
. When locking, be sure to carry the
access key to prevent locking the access
key in the vehicle.
. The setting of the hazard warning
flasher operation and the volume of the
audible signal can be changed by your
SUBARU dealer. We recommend that you
contact your SUBARU dealer for details.
. The setting of the hazard warning
flasher operatio n can be changed by
operating the multi function display. For
details, refer to “Keyless Entry System”
F3-50.
! Unlocking
Carry the access key, and grip either of
the front door handles. Then the following
door(s) is/are unlocked, and the hazard
warning flashers will flash twice.
. Only the driver’s door (models with
double locking system when gripping the
driver’s door handle)
. All doors and the rear gate (Outback)
(in other cases)
Keys and doors/Keyless access with push–button start system
2-13
– CONTINUED –
2
To Next Page
Loading...
