Black plate (205,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
illuminate.
The headlights and exterior lights will turn
off when any of the following conditions
occur.
. 30 seconds have passed since the
driver’s door was closed.
. Youpressthelockbuttononthe
access key/transmitter two times succes-
sively.
. You touch the door lock sensor on the
door handle two times successively (mod-
els with “keyless access with push-button
start system”).
NOTE
. While the headlight off delay func-
tion is operating, if you perform any of
the following operation, the headlights
and exterior lights will turn off.
– Turn the ignition switch to the
“ON” position.
– Pull the turn signal lever toward
you.
– Set the light control switch to a
position other than the “AUTO” or
“OFF” position.
. If the driver’s door is not opened
and closed, these lights will turn off in 3
minutes.
! Sensor of the auto on/off headlights
(if equipped)
The sensor is on the windshield glass as
shown in the illustration.
CAUTION
If any object is attached on or near
the sensor, the sens or may not
detect the level of the ambient light
correctly and the auto on/off head-
lights may not operate properly.
& High/low beam change
(dimmer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “
” on the combina-
tion meter also illuminates.
To switch back to low beam, pull the lever
back to the center position.
! High beam assist function (if
equipped)
NOTE
. Do not overestimate the capacity of
the high beam assist function. The
driver always has the responsibility to
understand the surrounding situation,
to drive safely, and to change the
headlight mode manually if necessary.
Instruments and controls/Light control switch
3-53
– CONTINUED –
3
To Next Page
Loading...
