Black plate (457,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
4. Hold the access key with the buttons
facing you, and touch the push-button
ignition switch with it.
When the communication between the
access key and the vehicle is completed,
a chime (ding) will sound. At the same
time, the status of the push-button ignition
switch changes to either of the following.
. When the keyless access with push-
button start system is deactivated:
“ACC”
. Under other conditions: “ON”
5. When the keyless access with push-
button start system is deactivated, press
the push-button ignition switch with the
clutch pedal (MT models) or brake pedal
(CVT models) released. The status of the
push-button ignition switch then changes
to “ON”.
NOTE
If the power does not switch even
though the above procedure was fol-
lowed precisely, we recommend that
you contact your SUBARU dealer.
& Starting engine
1. Apply the parking brake.
2. Shift the shift lever into neutral (MT
models) or the select lever into the “P”
position (CVT models).
3. Depress the brake pedal.
4. Depress the clutch pedal (MT models).
Left-hand drive models
Right-hand drive models
5. Hold the access key with the buttons
facing you, and touch the push-button
ignition switch with it.
When the communication between the
access key and the vehicle is completed,
a chime (ding) will sound. At the same
time, the push-button ignition switch turns
to the “ACC” or “ON” position.
6. While depressing the brake pedal (all
models) and the clutch pedal (MT mod-
els), press the push-button ignition switch.
NOTE
If the engine does not start even
though the above procedure was fol-
lowed precisely, we recommend that
you contact your SUBARU dealer.
In case of emergency/Access key – if access key does not operate properly
9-29
9
To Next Page
Loading...
