Black plate (70,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
1-38
Seat, seatbelt and SRS airbags/Child restraint systems
Outback
10. If the child restraint system requires a
top tether, latch the hook onto the top
tether anchorage and tighten the top
tether. For additional instructions, refer to
“Top tether anchorages” F1-42.
11. To remove the child restraint system,
press the release button on the seatbelt
buckle and allow t he belt to retract
completely. The belt will return to the
ELR mode.
NOTE
When the child restraint system is no
longer in use, remove it and restore the
ELR mode of the retractor. That mode
is restored by allowing the seatbelt to
retract fully.
& Installing a booster seat
1. Place the booster seat in the rear
seating position and sit the child on it. The
child should sit well back on the booster
seat.
2. Run the lap and shoulder belt through
or around the booster seat and the child
following the instructions provided by its
manufacturer.
3. Insert the tongue plate into the buckle
until you hear a click. Take care not to
twist the seatbelt.
Make sure the shoulder belt is positioned
across the center of child’s shoulder and
that the lap belt is positioned as low as
possible on the child’s hips.
To Next Page
Loading...
