Black plate (347,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
CAUTION
If you restart the engine while the
vehicle is moving, shift the select
lever into the “N” position. Do not
attempt to place the select lever of a
moving vehicle into the “P” posi-
tion.
! CVT diesel engine models
1. Apply the parking brake.
2. Turn off unnecessary lights and ac-
cessories.
3. Shift the select lever to the “P” or “N”
position (preferably “P” position).
Preheating indicator light
4. Turn the ignition switch to the “ON”
position and check the operation of the
warning and indicator lights. At this time,
confirm that the preheating indicator light
has illuminated for a few seconds and has
turned off. Refer to “Warning and indicator
lights” F3-14.
5. Turn the ignition switch to the “START”
position without depressing the accelera-
tor pedal. Release the key immediately
after the engine has started.
6. Confirm that all warning and indicator
lights have turned off after the engine has
started. The fuel injection system auto-
matically lowers the idle speed as the
engine warms up.
While the engine is warming up, make
sure that the select lever is at the “P” or
“N” position and that the parking brake is
applied.
CAUTION
If you restart the engine while the
vehicle is moving, shift the select
lever into the “N” position. Do not
attempt to place the select lever of a
moving vehicle into the “P” posi-
tion.
NOTE
You may feel vibration during engine
idling for several tens of seconds. This
vibration is caused by a self-learning
procedure of the injector. This learning
procedure is necessary to stabilize the
best engine performance. Therefore, it
does not indicate a malfunction.
& Stopping engine
The ignition switch should be turned off
only when the vehicle is stopped and the
engine is idling.
WARNING
Do not stop the engine when the
vehicle is moving. This will cause
loss of power to the power steering
and the brake booster, making steer-
ing and braking more difficult. It
could also result in accidental acti-
vation of the “LOCK” position on the
ignition switch, causing the steering
wheel to lock.
Starting and operating/Starting and stopping engine (models without push–button start system)
7-9
7
To Next Page
Loading...
