Subaru Outback 2016 - Initialization of Power Window

Black plate (140,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
2-30 Keys and doors/Windows
up until it clicks and release it, and the
window will fully close. To stop the window
halfway, push the switch down lightly.
NOTE
For models with the one-touch auto up/
down function, if the vehicle’s battery
is disconnected due to situations such
as battery or fuse replacement, the
one-touch auto up/down function will
be deactivate d. I nitial ize t he po wer
window to reactivate the one-touch
auto up/down function. Refer to “Initi-
alization of power window” F2-30.
! Anti-entrapment function (models
with the one-touch auto up/down
feature)
CAUTION
. Never attempt to test this func-
tion using fingers, hands or other
parts of your body.
. The anti-entrapment function
may not operate properly if some
object gets trapped just before
the window fully closes.
NOTE
. If a window detects an impact simi-
lar to that caused by trapping an object
(for example, when the vehicle encoun-
ters a deep pothole), the anti-entrap-
ment function may operate.
. The window cannot be operated for
a few seconds after the anti-entrap-
ment function operates.
. If the vehicle’s battery is discon-
nected due to si tuations such as
battery or fuse replacement, the anti-
entrapment function will be deacti-
vated. Initialize the power window to
reactivate the anti-entrapment function.
Refer to “Initialization of power win-
dow” F2-30.
While closing with the one-touch auto up
function, if the window senses a substan-
tial enough object trapped between the
window and the window frame, it auto-
matically moves down slightly and stops.
& Initialization of power win-
dow
If the vehicle’s battery is disconnected due
to situations such as battery or fuse
replacement, the following functions are
deactivated.
. One-touch auto up/down function
. Anti-entrapment function
Initialize the power window in the following
procedure to reactivate such functions.
Perform the following procedure for each
of the doors that have the one-touch auto
up/down function.
1. Close the door.
2. Turn the ignition switch to the “ON”
position.
3. Open the window of the door that you
have closed in step 1 halfway by pushing
down the power window switch.
4. Pull up the power window switch of the
door that you have closed in step 1 and
close the window completely. Continue
pulling up the switch for approximately 1
second after the window is closed com-
pletely.