Black plate (157,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
& ACC
In this position the electrical accessories
(audio, accessory power outlet, etc.) can
be used.
& ON
This is the normal operating position after
the engine is started.
& START
The engine is started in this position. The
starter cranks the engine to start it. When
the key is released (after the engine has
started), the key automatically returns to
the “ON” position.
CAUTION
Do not turn the ignition switch to the
“START” position while the engine
is running.
As your vehicle is equipped with an
immobilizer system, if you fail to start your
engine with your registered key, pull out
the key once, (at this time, the immobilizer
indicator light blinks) and then insert the
key in the ignition switch and turn it to the
“START” position and again try to start
your engine.
NOTE
The engine may not start in the follow-
ing cases.
. The key grip is touching another key
or a metallic key holder.
. The key is near another key that
contains an immobilizer transponder.
. The key is near or touching another
transmitter.
& Key reminder chime (Middle
East models)
The reminder chime sounds when the
driver’s door is opened and the ignition
switch is in the “LOCK” or “ACC” position.
The chime stops unde r the following
conditions.
. when the ignition switch is turned to the
“ON” position
. when the key is removed from the
ignition switch
. when the driver’s door is closed
& Ignition switch light
For easy access to the ignition switch in
the dark, the ignition switch light illumi-
nates when driver’s door is opened or
when the driver’s door is unlocked using
the remote keyless entry transmitter.
The light remains illuminated for approxi-
mately 30 seconds and gradually turns off
under the following conditions.
. when the driver’s door is closed
. when the doors are unlocked using the
remote keyless entry transmitter
Instruments and controls/Ignition switch (models without push–button start system)
3-5
– CONTINUED –
3
To Next Page
Loading...
