Black plate (447,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
possible (within a maximum driv-
ing distance of 200 km (125
miles)). Do not continue to drive
if heavy vibrations, unsteady
steering behavior or noises oc-
cur while driving.
. Do not use tire chains on a sealed
tire.
. Do not tow a trailer.
12. Drive to the nearest SUBARU dealer
or other workshop to have the damaged
tire replaced.
WARNING
Before driving, ensure that the tire is
adjusted to the recommended infla-
tion pressure as indicated on the
vehicle placard. Monitor the tire
pressure until the sealed tire is
replaced.
13. Before the tire is removed from the rim,
inform your SUBARU dealer or other tire
dealer that the tire contains sealant.
CAUTION
Sealant deposits in a used hose of a
sealant application cap may impair
proper functioning of the compres-
sor. The bottle of sealant, sealant
application cap and speed limit label
need to be replaced after using the
flat tire repair kit.
NOTE
New sealant and replacement parts can
be purchased from your authorize d
repair shop or SUBARU dealer, and
they should also be installed into the
kit by a specialist. Empty sealant
bottles and replacement parts must be
returned to your SUBARU dealer or
disposed of in compliance with local
waste disposal regulations.
! Technical data of compressor
Line voltage DC 12V
Operating voltage DC 10 – 15V
Amperage
Max. 10A
& Tire pressure monitoring
system (TPMS) (if equipped)
Low tire pressure warning light
WARNING
When a spare tire is mounted, the
low tire pressure warning light will
illuminate steadily after blinking for
approximately one minute. This in-
dicates the TPMS is unable to
monitor all four road wheels. We
recommend that you contact your
SUBARU dealer as soon as possible
for system resetting. Refer to “Tire
pressure monitoring system
(TPMS)” F7-43.
When a tire is repaired with liquid
sealant, the tire pressure warning
In case of emergency/Flat tires
9-19
– CONTINUED –
9
To Next Page
Loading...
