Black plate (159,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
– On the floor
– Inside the glove box
– Inside the door trim pocket
– On the rear seat
– On the rear shelf (Sedan)
– Inside the trunk (Sedan)
– At the corner of the cargo area
(Outback)
. When operating the push -button
ignition switch or starting the engine,
if the access key battery is discharged,
perform th e procedure described in
“Access key – if access key does not
operate properly” F9-28. In su ch a
case, replace the battery immediately.
Refer to “Replacing battery of access
key” F11-62.
& Switching power status
Left-hand drive models
1) Operation indicator
2) Push-button ignition switch
Right-hand drive models
1) Operation indicator
2) Push-button ignition switch
The power is switched every time the
push-button ignition switch is pressed.
1. Carry the access key, and sit in the
driver’s seat.
2. Shift the shift lever into neutral (MT
models) or the select lever into the “P”
position (CVT models).
3. Press the push-button ignition switch
without depressing the clutch pedal (MT
models) or the brake pedal (CVT models).
Every time the button is pressed, the
power is switched in the sequence of
“OFF”, “ ACC”, “ON” and “OFF”. When the
engine is stopped and the push-button
ignition switch is in “ACC” or “ON”, the
operation indicator on the push -button
Instruments and controls/Push–button ignition switch (models with push–button start system)
3-7
– CONTINUED –
3
To Next Page
Loading...
