Subaru Outback 2016 - To Set Cruise Control

Black plate (384,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
7-46 Starting and operating/Cruise control
. If the cruise control indicator light
does not illuminate even after pressing
the cruise control main button, it is
possible that there is a malfunction in
the system. We recommend that you
contact your SUBARU dealer for an
inspection.
. Make sure the cruise control system
is turned off when the cruise control is
not in use to avoid unintentionally
setting the cruise control.
& To set cruise control
Cruise control main button
1. Press the cruise control main button.
Cruise control indicator light
The cruise control indicator light on the
combination meter will illuminate.
2. Depress the accelerator pedal until the
vehicle reaches to the desired speed.
3. Press the “RES/SET” switch to the
“SET” side and release it. Then release
the accelerator pedal.
Cruise control set indicator
1) When setting the di splayed unit as
“MPH”.
2) When setting the di splayed unit as
“km/h”.
At this time, the cruise control set indicator
appears in the combination meter. The set
speed will be shown on the combination
meter. You can change the displayed unit
by operating the multi information display.
For details, refer to “Units (U.K. models)”
F3-49.
The vehicle will maintain the desired
speed.
Vehicle speed can be temporarily in-
creased while driving with the cruise
control activated. Simply depress the