Subaru Outback 2016 User Manual

Black plate (40,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
1-8 Seat, seatbelt and SRS airbags/Front seats
driver’s door.
(2) Press the “
” button on the
access key or the door lock button
to lock the doors.
(3) Perform the prior procedures
again.
. If the keyless access func tion is
disabled, the seat position cannot be
retrieved by gripping the driver’s door
handle. However, the seat position can
still be retrieved by pressing the “
”
button on the access key. For informa-
tion about how to enable/disable the
keyless access function, refer to “Dis-
abling keyless access function” F2-16.
. If a new position is registered for the
same access key, the previously regis-
tered seat position is deleted.
! Clearing the registered seat
position with access key (if
equipped)
1. Close the driver’s door.
2. While holding the access key and
pressing the “SET” button, press the “
”
button on the access key.
A chirp will sound, and the registered seat
position will be cleared.
& Head restraint adjustment
WARNING
. Never drive the vehicle with the
head restraints removed because
they are designed to reduce the
risk of serious neck injury in the
event that the vehicle is struck
from the rear. Also, never install
the head restraints the opposite
way round. Doing so will prevent
the head restraints from func-
tioning as intended. Therefore,
when you remove the head re-
straints, you must reinstall all
head restraints correctly to pro-
tect vehicle occupants.
. All occupants, including the dri-
ver, should not operate a vehicle
or sit in a vehicle’s seat until the
head restraints are placed in their
proper positions in order to mini-
mize the risk of neck injury in the
event of a crash.
Both the driver’s seat and front passen-
ger ’s seat are equipped with head re-
straints. Both head restraints are adjusta-
ble in the following ways.
! Head restraint height adjustment
1) Head restraint
2) Release button
Each head restraint should be adjusted so
that the center of the head restraint is
closest to the top of the occupant’s ears.
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that

Subaru Outback 2016 Specifications

General

Brand	Subaru
Model	Outback 2016
Category	Automobile
Language	English