Black plate (39,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
involving serious injury or death.
LHD models
RHD models
1. Turn the ignition switch to the “ON”
position.
2. While the select lever is in the “P”
position (CVT models) and the parking
brake is applied, press button “1” or “2”.
A chirp sounds and the seat moves to the
registered position.
When the seat moves to the registered
position, a chirp will sound.
NOTE
. If a new position is registered for the
same button, the previously registered
seat position is deleted.
. If the vehicle battery is removed, the
registered seat position is not deleted.
. When the button “1” or “2” is
pressed within 45 seconds after the
driver’s door is opened, the registered
seat position can be retrieved even if
the ignition switch is in the “LOCK” or
“OFF” position.
! Retrieval of the seat position
registered with access key (if
equipped)
1. Hold the registered access key.
2. Unlock the driver’s door by pressing
the “
” button or gripping the door handle.
3. Open the driver’s door.
A chirp sounds and the seat moves to the
registered position.
When the seat moves to the registered
position, a chirp will sound.
NOTE
. If the registered seat position cannot
be retrieved after performing the pre-
vious procedu res, try the following
procedures.
(1) Press the “SET” button on the
Seat, seatbelt and SRS airbags/Front seats
1-7
– CONTINUED –
1
To Next Page
Loading...
