Black plate (65,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
the extended position. If the child restraint
system still makes contact, remove the
head restraint. For details, refer to “Head
restraint adjustment” F1-8.
! Installation procedure
. For the installation procedure, refer to
“Installing child restraint systems with
seatbelt” F1-33.
& Installing child restraint sys-
tems with seatbelt
WARNING
. Child restraint systems and seat-
belts can become hot in a vehicle
that has been closed up in sunny
weather; they could burn a small
child. Check the child restraint
system before you place a child
in it.
. Do not leave an unsecured child
restraint system in your vehicle.
Unsecured child restraint sys-
tems can be thrown around in-
side of the vehicle in a sudden
stop, turn or accident; they can
strike and injure vehicle occu-
pants as well as result in serious
injuries or death to the child.
CAUTION
When you install a child restraint
system, follow the manufacturer’s
instructions supplied with it. After
installing the child restraint system,
check to ensure that it is held
securely in position. If it is not held
tight and secure, the danger of your
child suffering personal injury in the
event of an accident may be in-
creased.
First check if the Automatic Locking
Retractor (ALR) is equippe d for the
seatbelts of the vehicle according to the
following procedure.
1. Draw out the seatbelt completely.
2. Retract the seatbelt even slightly and
try to draw out the seatbelt again.
3. If the seatbelt is locked in that position
and cannot be extended, it indicates that
an ALR is equipped for the seatbelt.
When the seatbelt is retracted fully, the
ALR mode is canceled and the Emer-
gency Locking Retractor (ELR) mode is
restored.
NOTE
. For details about the ELR, refer to
“Emergency Locking Retractor (ELR)”
F1-16.
. For details about the ALR, refer to
“Automatic Locking Retractor/Emer-
gency Locking Retractor (ALR/ELR)”
F1-16.
! Installing a rearward facing child
restraint
NOTE
. For models with ALR:
If using ALR mode is recommended by
the manufacturer’s instructions sup-
plied with the child restraint system,
use ALR mode.
1) Lock-off device
2) Locking clip
. If using the lock-off device or the
locking clip is recommended by the
manufacturer’s instruc tions supplied
Seat, seatbelt and SRS airbags/Child restraint systems
1-33
– CONTINUED –
1
To Next Page
Loading...
Need help?
General
