Black plate (66,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
1-34
Seat, seatbelt and SRS airbags/Child restraint systems
with the child restraint system, use the
lock-off device or the locking clip to
secure the child restraint system.
Through the following steps, the child
restraint system is fastened with a seatbelt
that is set to ELR mode.
1. Place the child restraint system in the
rear seating position.
2. Run the lap and shoulder belt through
or around the child restraint system
following the instructions provided by its
manufacturer.
3. Insert the tongue plate into the buckle
until you hear a click.
4. Take up the slack in the lap belt.
5. Push and pull the child restraint
system forward and from side to side to
check that it is firmly secured.
6. To remove the child restraint system,
press the release button on the seatbelt
buckle.
WARNING
NEVER INSTALL A FORWARD OR
REARWARD FACING CHILD SEAT
IN THE FRONT PASSENGER’S
SEAT. DOING SO RISKS SERIOUS
INJURY OR DEATH TO THE CHILD
BY PLACING THE CHILD’S HEAD
TOO CLOSE TO THE SRS AIRBAG.
! Installing forward facing child re-
straint
If the ALR is not equipped for the seatbelt,
refer to “Models without ALR” F1-35.
If the ALR is equipped for the seatbelt,
refer to “Models with ALR” F1-36.
CAUTION
Do not place the head restraint that
has been removed in the passenger
compartment to prevent it from
being thrown around in the passen-
ger compartment in a sudden stop
or a sharp turn.
To Next Page
Loading...
