Black plate (206,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
3-54
Instruments and controls/Light control switch
. Obser ve the following points in
order to operate the high beam assist
function properly.
– Do not touch the camera or the
lens.
– Do not apply any strong impact
to the camera or the inside mirror.
– Do not disassemble the camera
or inside mirror.
– Do not spill liquid on the inside
mirror and camera.
– Do not place any objects over the
dashboard.
– Do not carry excessive luggage.
– Do not modify the vehicle.
– When replacing the windshield
glass, use the genuine SUBARU
parts (or equivalent products).
1) Camera for high beam assist function
NOTE
Observe the following points in order
to operate the high beam assist func-
tion properly.
. Do not attach labels or stickers to
the windshield glass near the camera.
. Do not attach any accessories near
the inside mirror and camera.
For models with the EyeSight system,
refer to the Owner’s Manual supple-
ment for the EyeSight system.
The high beam assist function automati-
cally changes the headlight from high
beam to low beam (or vice versa). When
all of the following conditions are met, the
headlight will change to high beam.
. When the vehicle speed increases to
or above the preset level.
*1
. There is no preceding vehicle.
. The forward area of the vehicle is dark.
When any of the following conditions is
met, the headlight will change to low
beam.
. When the vehicle speed decreases to
or below the preset level.
*2
. When the forward area of the vehicle is
bright.
. When there is a preceding or oncoming
vehicle.
*1:
Type A: 35 km/h (22 mph) or more,
Type B: 40 km/h (25 mph) or more,
Type C: 55 km/h (34 mph) or more,
To Next Page
Loading...
