Black plate (207,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
*2:
Type A: 27 km/h (17 mph) or less
Type B: 30 km/h (19 mph) or less
Type C: 45 km/h (28 mph) or less
NOTE
. The pres et vehicle speed varies
depending on the models.
. The factory setting (default setting)
for this function is set as “operational”.
This setting can be changed to OFF
(non-operation) at SUBARU dealers.
For more details, we recommend that
you contact a SUBARU dealer.
! How to use the high beam assist
function
The high beam assist function will be
activated when all the following conditions
are met.
. The light control switch is in the
“AUTO” position and the low beam head-
lights are on automatically.
. The turn signal lever is pushed forward.
High beam assist indicator (green)
When the high beam assist function is
activated, the high beam assist indicator
on the combination meter will illuminate.
Malfunction of the high beam assist
function:
High beam assist warning indicator
(yellow)
When the hi gh beam assi st function
malfunctions, the high beam assist warn-
ing indicator on the combination meter will
appear. In this case, we recommend that
you have your vehicle inspected by your
SUBARU dealer.
Temporary stop of high beam assist
function:
If the high beam assist function stops
temporarily due to poor visibility or abnor-
mal temperature, the message appears
on the combination meter. When the
condition is canceled, the system will be
restored.
Instruments and controls/Light control switch
3-55
– CONTINUED –
3
To Next Page
Loading...
