Black plate (349,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
Charge the battery.
Left-hand drive models
1) Operation indicator
2) Push-button ignition switch
Right-hand drive models
1) Operation indicator
2) Push-button ignition switch
! MT models
1. Carry the access key, and sit in the
driver’s seat.
2. Apply the parking brake.
3. Shift the shift lever in neutral.
4. Depress the brake pedal.
5. Depress the clutch pedal until the
indicator on the pu sh-button ignitio n
switch turns green.
6. While depressing the clutch pedal,
press the push-button ignition switch.
NOTE
. In case the engine does not start by
the normal engine start procedure,
move the shift lever to the neutral
position, and switch the power to
“ACC”. Depress the clutch pedal, and
press the push-button ignition switch
for at least 15 seconds. The engine may
start. Only use this engine start proce-
dure in case of emergency.
. The engine will not start until the
preheating indicator light has turned
off.
. You may feel vibration during engine
idling for several tens of seconds. This
vibration is caused by the self-learning
procedure of the injector. This learning
procedure is necessary for optimum
engine performance. This does not
indicate a malfunction.
! CVT models
1. Carry the access key, and sit in the
driver’s seat.
2. Apply the parking brake.
3. Shift the select lever in the “P” posi-
tion. The engine can also start when the
select lever is in the “N” position, however,
for safety reasons, start in the “P” position.
4. Depress the brake pedal until the
operation indicator on the push -button
ignition switch turns green. When starting
Starting and operating/Starting and stopping engine (models with push–button start system)
7-11
– CONTINUED –
7
To Next Page
Loading...
