Black plate (37,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
the seat cushion angle or seat cushion
height.
2) Seat cushion angle control switch
To adjust the seat cushion angle, pull up
or push down the front end of the control
switch.
3) Seat height control switch
To adjust the seat height, pull up or push
down the rear end of the control switch.
4) Seatback angle (reclining) control
switch
To adjust the angle of the seatback,
move the control switch.
5) Lumbar support control switch (dri-
ver’s seat only)
To increase lower back support, push the
front side of the switch. To decrease
lower back support, push the rear side of
the switch.
! Memory function (driver’s seat — if
equipped)
WARNING
. To avoid loss of vehicle control or
personal injury, never perform
the following operations while
driving.
– Adjusting the seat
– Retrieving the seat position
. Before adjusting the seat, make
sure that cargo or the hands and
feet of rear seat passengers are
clear of the adjusting mechan-
ism.
. Perform the seat position retrie-
val before driving. Be sure to
confirm that the select lever is
in the “P” position (CVT models),
and the parking brake is applied,
when adjusting the seat position.
Do not drive until the retrieval of
the seat position is complete.
. When retrieving a registered seat
position, make sure the hands,
feet and possessions of rear seat
passengers are clear of the seat
adjusting mechanism.
. When any unusual conditions or
malfunctions occur during the
retrieval of the seat position, stop
the retrieval of the seat position
by performing any of the follow-
ing procedures.
– Operate any of the power seat
switches
– Press the “SET” button
– Press button “1” or “2”
Some of your desired seat positions can
be registered. Register the seat position
with button “1” or “2” or each of the access
keys (if equipped) and retrieve the seat
position.
The followin g seat positions can be
registered.
. Forward/backward position of the seat
. Angle of seatback
. Angle of seat cushion
. Height of seat
! Registration of seat position with
button “1” or “2”
1. Adjust the seat position under the
following conditions.
. The parking brake is applied.
. The ignition switch is in the “LOCK”/
“OFF” position.
. The select lever is in the “P” position
(CVT models).
Seat, seatbelt and SRS airbags/Front seats
1-5
– CONTINUED –
1
To Next Page
Loading...
