Black plate (418,1)
一般Model "A2520GE-A" EDITED: 2015/ 10/ 22
8-18
Driving tips/Loading your vehicle
3. Install the bars into the holders.
4. Make sure that the latches are fitted
securely.
! How to change the position of the
crossbar
CAUTION
Carefully read the caution label
attached to the roof rail.
You can change the position of the rear
crossbar. To change the position, perform
the following procedure.
1. Take out the torque wrench from the
under-floor storage compartment.
2. Undo the cap of the roof rail holder by
using the torque wrench.
3. Undo the bolt of the crossbar by using
the torque wrench.
4. Pull out the crossbar from the roof rail
holder by pulling up the cover.
5. Install the crossbar into the other
holder.
6. Tighten the bolt of the crossbar by
using the torque wrench. The tightening
To Next Page
Loading...
