84 Netra T2000 Server Installation Guide • September 2006
▼ To Reset the System Controller
After all of the configuration parameters are set, you must reset the system controller
for the new values to take affect.
● Issue the resetsc command.
You are prompted to confirm that you want to reset the system controller. Reply y
when prompted.
Note – You can specify the –y flag to the resetsc command and bypass the
confirmation message.
The system controller resets, runs diagnostics, and returns to the login prompt.
ser_stopbits 1
ser_data 8
netsc_enetaddr 00:03:ba:81:2d:02
sys_hostname
sys_enetaddr 00:03:ba:81:2c:f9
sc> resetsc
Are you sure you want to reset the SC [y/n]? y
User Requested SC Shutdown
ALOM POST 1.0
Dual Port Memory Test, PASSED.
TTY External - Internal Loopback Test
TTY External - Internal Loopback Test, PASSED.
TTYC - Internal Loopback Test
TTYC - Internal Loopback Test, PASSED.
TTYD - Internal Loopback Test
TTYD - Internal Loopback Test, PASSED.
TABLE 6-1 Sample Configuration Parameter Setting (Continued)
Parameter Sample Value
To Next Page
Loading...
Need help?
General
