22 Netra T2000 Server Installation Guide • September 2006
4-Post Rackmounting Options
The server ships with a 19-inch, 4-post hardmount rack kit (see “To Install a Server
With a Hardmount 19-Inch 4-Post Rack” on page 22 for installation instructions).
TABLE 3-1 lists three additional 4-post rackmount kit options that can be ordered from
Sun. This chapter provides installation instructions for these rackmount kit options.
Note – If you have more than six DC-powered servers in the same rack, you might
exceed Telcordia NEBS EMI limits.
Hardmounting the Server in a 19-Inch 4-
Post Rack
▼ To Install a Server With a Hardmount 19-Inch 4-
Post Rack
The hardmount kit for a 19-inch 4-post rack consists of:
■ Two hardmount brackets
■ Two rear mount support brackets
■ Two rear mount flanges
■ Bag of screws
TABLE 3-1 Optional Rackmount Kits
Mounting Kit Installation Instructions
19-inch, 4-post slide mount kit for
600–800 mm cabinet depths
“To Install a Server With a Sliding Rail Mount in a
19-Inch 4-Post Rack” on page 26
600 mm x 600 mm rackmount kit “To Install a Server With a Hardmount in a 600-mm
4-Post Rack” on page 33
19-inch, 4-post slide rail kit for 800–
1000 mm cabinet depths with cable
management assembly
“Installing a Server With a Hardmount in a 19-Inch
4-Post Rack for Use With the Cable Management
Assembly” on page 41
To Next Page
Loading...
Need help?
General
