16 Netra T2000 Server Installation Guide • September 2006
17. Install any required patches to the server.
Refer to the server product notes for a list of the required patches.
18. Load additional software from the optional Solaris media kit.
The Solaris media kit (sold separately) includes several CDs containing software
to help you operate, configure, and administer your server. Refer to the
documentation provided with the media kit for a complete listing of included
software and detailed installation instructions.
Installing the Air Filter
The server ships with a protective shipping insert located between the bezel and the
front panel. You must remove this protective insert and replace it with an air filter
before powering on the server.
Caution – Failure to remove the shipping insert from the front bezel can block the
air from flowing through the server, which would seriously damage the server
components.
1. Grip the bezel at the two finger holds and rotate it down to its open position
(
FIGURE 2-1).
FIGURE 2-1 Finger Holds on Bezel
2. Carefully remove the shipping insert from the inside of the bezel.
3. Obtain the air filter that shipped with your server.
4. Snap the new air filter into place in the bezel (
FIGURE 2-2).
To Next Page
Loading...
Need help?
General
