Chapter 6 Powering On the Server 81
The sc prompt is displayed the first time the system controller is booted. The default
configuration provides an ALOM user account called admin. There is no default
password, so you must create a password using the system controller (sc)
password command.
1. If this is the first time the server has been powered on, use the password
command to set the admin password.
After the admin password has been set, on subsequent reboots, the sc login prompt
is displayed.
2. Enter admin for the login name followed by your password.
▼ To Configure the System Controller Network
Management Port
To access the system controller using the network for the first time, you must first
configure the SC network management port through the SC serial management port.
Set these network parameters according to the specific details of your network
configuration:
.........................
TTYD - - PASSED
TTYC - - PASSED
MEMORY - - PASSED
MPC885 - - PASSED
sc> password
password: Changing password for admin
Setting password for admin.
New password: new-password
Re-enter new password: new-password
sc>
TTYD - - PASSED
TTYC - - PASSED
MEMORY - - PASSED
MPC885 - - PASSED
Please login: admin
Please Enter password: password
(Press Return twice)
sc>
To Next Page
Loading...
Need help?
General
