82 Netra T2000 Server Installation Guide • September 2006
■ netsc_ipnetmask – Netmask for the system controller subnet
■ netsc_ipaddr – IP address of the system controller
■ netsc_ipgateway – IP address of the gateway for the subnet
■ if_network – Specifies whether the SC is on the network or not
To configure these parameters you must use the setsc command. The usage is:
setsc parameter
1. Set the netmask for the system controller.
This example uses 255.255.255.0 to set the netmask. Your network environment
subnet might require a different netmask. Use a netmask number most appropriate
to your environment.
2. Set the IP address for the system controller.
3. Set the IP address for the system controller gateway.
4. Set the if_network parameter to true.
5. Use the showsc command to verify that the parameters were set correctly.
The showsc command displays all the configuration parameters and their values, as
listed in
TABLE 6-1.
sc> setsc netsc_ipnetmask 255.255.255.0
sc> setsc netsc_ipaddr service-processor-IPaddr
sc> setsc netsc_ipgateway gateway-IPaddr
sc> setsc if_network true
To Next Page
Loading...
Need help?
General
