SunStar SPS/E-BH6100 - Pattern Number and Thread Tension Adjustment; Changing Pattern Number; Adjusting Thread Tension

19
9) Change the pattern number
① When the READY lamp is off, and the DOWN key is pressed,
NO. on the LCD is flickering.
② Use ◀(+) or ▶(-) keys to choose the desired pattern number.
(ex: Pattern No. 5)
③ Confirm the selection by pressing ENTER and the chosen
pattern is automatically generated.
↓
↓
OR
↓
When the DOWN key is pressed, the blinking section moves down on the LCD and vice versa. When
ENTER is pressed, the blinking section disappears from the screen and the chosen value is stored.
Caution
① When the sewing ready lamp is off, press the Down key five
times and the prompt blinks at ‘0030’section on the screen.
② Use ◀(+) or ▶(-) keys to select a desired thread tension number.
(ex : TENS. : 35)
③ Confirm the selection by pressing ENTER and the chosen pattern
is automatically generated.
↓
↓
OR
↓
10) Adjusting the thread tension