45
① Press UP or DOWN key on the initial parameter screen and
select “3”.
② Press ENTER, and a new screen appears.
② Press UP or DOWN key to set the right knife space. When the
space is determined, select “5”, and press ENTER.
◀Note▶
“5 : CP Type” is displayed only when the sewing
machine is BH6100-02.
③ Press ◀(+) or ▶(-) to set a desired value, and press ENTER.
O.K. message is displayed on the screen
③ (Ex : Clamp type → C : 26~32mm)
④ A new screen appears in one second. Press DOWN key to
select [RETURN] and then press ENTER. The screen returns
to the original setup screen.
4) Clamp type (sewing size) setting
OR
↓
OR
OR
↓
↓
↓
↓
↓
↓
↓
Type Clamp size (sewing scope)
A 14[mm] ~ 20[mm]
B 20[mm] ~ 26[mm]
C 26[mm] ~ 32[mm]
D 32[mm] ~ 40[mm]
1) According to pattern number, a clamp with different size should be selected.
2) If the clamp device is not changed in line with clamp type, operation errors and damage to machine
might occur.
3) When initializing a BH6100-02 type machine, the clamp size should be “C : 26-32mm”.
If the clamp device is not C type is used, make sure of selecting “5 : CP Type”.
Caution
To Next Page
Loading...
