31
4) Create the pattern data
① Press ENTER, and the initial display for parameter information
setting appears.
② Select [HOME] or [RETURN] by using the UP or DOWN
key.
③ Press ENTER, and a pattern is created based on the changed
parameter information.
④ When the pattern creation is completed, it automatically returns
to the initial display.
OR
↓
◀Note▶ Shape of Pattern with Taper
When the Offset value increases, the taper gets narrower. When the Offset value
decreases, the taper gets wider.
Taper Width
offset
•Function keys can be used only in the [DATAINFO] routine.
•When creating patterns, press READY within the basic pattern creation routine. Then basic pattern
is generated, and the screen moves back to the initial display.
Caution
To Next Page
Loading...
