26
6-3) Create the basic pattern shapes
6-3-1) Taper pattern
① Make sure that the sewing READY lamp is off, and press the
DOWN key to choose DATAINFO. Press ENTER and it moves
to the initial display for parameter information change.
② Press the UP, DOWN keys, and choose ‘2: Pattern’.
③ Press ENTER and the screen of choosing button shapes appears.
Select the desired pattern using Up or Down and press ENTER
(ex: Taper shape pattern).
1 : Taper (Taper Pattern)
2 : Tack (Square Bartack Pattern)
3 : Radial (Radiation pattern shape)
4 : Eyelet (Eyelet Pattern)
④ The screen for pattern creation pops up.
To create a pattern, up and down bartacks and the zigzag part
should be set.
1 : Up Bar (Up bartack part)
2 : Zigzag (Zigzag part)
3 : Dn Bar (Down bartack part)
※ Repeat the ①, ②, ③ procedures to set the up bartack part, the zigzag part and the down bartack part.
↓
↓
OR
↓
•When you desire to generate patterns with default values, press READY at the step
④
.
•“4:Eyelet” is displayed only when A-16 of the Parameter Group is changed to “1:enabled”. When
“4:Eyelet” is displayed, it is possible to produce the eyelet pattern.
Caution
To Next Page
Loading...
