71
① Please turn on the electric power while pressing the key
and the READY key. And then the parameters related to
the sewer and the motor will be initialized to the default
values while it will display a message on the screen.
② It will display the initial logo on the screen while transforming
after that it will have completed to initialize.
(Case of 『BH6100-01』)
※ To shift to the sewing mode, press the right-side hand switch.
7-2) Exactly necessary operation after exchanged the program ROM
(hold on)
+
(hold on)
+
“Power ON”
1) The first things execute the initialize.
① Make sure that the sewing READY lamp is off, and use the
UP or DOWN key to select No.
② Use ▶(-) key to set the desired pattern number at ‘0000’.
Then the screen automatically moves to the next one.
③ Press ENTER and the setup menu appears.
1. ORIGIN : Set the original point and the automatic highest
stop position.
2. FORMAT : Reset the parameter default values related to
pattern.
④ Use the DOWN key to select ‘HOME’ and press ENTER. The
screen switches to the initial sewing mode.
◀Note▶
Pay attention to the fact that the pattern number
always changes to ‘0001’.
2) And then execute the format
↓
↓
↓
↓
OR
↓
↓
BH6100-01
To Next Page
Loading...
Need help?
General
