6
11
Machine Safety Regulations
Safety instructions in this manual are defined as Danger, Warning and Caution.
If you do not follow the instructions, physical injuries or machine damage might occur.
Danger : This mark must be observed. Otherwise, danger could result during installation, transportation and operation of the
machine.
Warning : When you keep this indication, injuries caused by the machine can be prevented.
Caution : When you keep this indication, machine errors could be prevented.
1-1) Transportation
Danger
1-2) Installation
Warning
1-3) Repair
Caution
Those who fully understand the safety regulations should transport the machine. The
following instructions must be followed.
ⓐ At least two people should move the machine.
ⓑ To prevent occurrence of accidents during transportation, thoroughly wipe off the oil put on
the surface of the machine.
The machine may not work properly or break down depending on where it is installed. The
right place of installation should meet the following conditions.
ⓐ Remove the package and wrappings from the top in order. Take a special notice of the
nails on the wooden box.
ⓑ Dust and moisture stains and rusts the machine. Install air-conditioners and clean the
machine regularly.
ⓒ Keep the machine away from direct sunlight.
ⓓ Leave the space of at least 50cm between the wall and the left, right and rear sides of the
machine for repairing.
ⓔ Explosion
Do not use the machine in the atmospheres exposed to the danger of explosion.
To avoid explosion, do not operate this machine in a place where a large quantity of
aerosol products is used or where oxygen is stored, unless there are specific facilities
installed to prevent explosion.
ⓕ The machine doesn’t provide lightings. End users should install them at their workplace.
When the machine needs to be repaired, only the designated A/S engineers, who were educated
by Sunstar, should repair the machine.
ⓐ Before cleaning or repairing the machine, turn off the machine and wait for 5 minutes till
the machine is completely discharged.
ⓑ The machine specifications or parts should not be altered without prior consultation with
the company. This may pose a danger to operation.
ⓒ When repairing, only the original spare parts produced by the company should be used for
replacement.
ⓓ Put all the safety covers back on the machine after repairing is complete.
To Next Page
Loading...
Need help?
General
