SunStar SPS/E-BH6100 - Up Bartack Shape for Square Bartack

33
⑤ Press UP or DOWN to select ‘1’and press ENTER.
ex) Select ‘1: Up Bar’
⑥ To create the up bartack shape, it is necessary to enter the number
of eyelet stitches and the values for the X,Y-direction knife space.
The number of eyelet stitches can be changed by pressing
ENTER.
⑦ Set the desired value using ◀(+) and ▶(-) and press ENTER.
Then the O.K.! message is displayed.
(ex: 0009)
⑧ In one second, the screen automatically moves to the previous
screen. Select ‘2’by pressing DOWN to set the Y-direction
knife space of the eyelet, and press ENTER.
⑨ Set the desired value using ◀(+) and ▶(-), and press ENTER.
Then the O.K.! message is displayed.
(ex : 0000)
⑩ In one second, the screen automatically moves to the previous
screen . Select ‘3’by pressing DOWN to compensate the eyelet
slant, and press ENTER.
⑪ Set the desired value using ◀(+) and ▶(-), and press ENTER.
Then the O.K.! message is displayed.
(ex: 0001)
1) Create the up bartack shape
OR
OR
OR
OR
OR
OR
OR
↓
↓
↓
↓
↓
↓
↓
↓
↓
↓
↓
↓
↓