SunStar SPS/E-BH6100 - Compensation of Zigzag Part; Adjusting Zigzag Rotation, Length, and Width

49
6-6) Compensation of the zigzag part
① Make sure that the READY lamp is off, and press the DOWN
key five times. It makes DATAINFO blink. Press ENTER and
the initial parameter setting display appears.
② Select ‘5: L_Comp.’ using the UP or DOWN key on the screen
and press ENTER.
③ A new screen pops up and ‘1’ blinks. Select ‘1’ by using the
UP or DOWN key and press ENTER to compensate the
rotation value.
④ On the value setting screen, set the desired value using ◀(+)
and
▶(-), and press ENTER. Then the O.K.! message
appears.
⑤ A new screen appears and ‘1’blinks. To compensate the
zigzag part, select ‘2’using UP or DOWN and press ENTER.
⑥ Set the desired value using ◀(+) and ▶(-) and press ENTER.
The O.K.! message is displayed.
◀Note▶
Around the zigzag part, the pitches are different.
⑦ The menu screen appears, and ‘2’blinks. Select ‘3’ using UP
or DOWN to compensate the width of the pattern, and press
ENTER.
⑧ When a new screen appears, select the desired value pressing
◀(+) and ▶(-), and press ENTER. The O.K.! message is
displayed.
+ direction: Pattern width increases.
- direction: Pattern width decreases.
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
↓
↓
↓
↓