SunStar SPS/E-BH6100 - Auxiliary Output Test(Aux. out Test)

68
③ When pressing the right hand switch, the new screen appears,
and the lamp of the clamp Up/Down( ) key is turned on.
④ When pressing the left hand switch, a different screen appears
and the lamp of the READY ( ) key is turned on.
⑤ When pressing the left hand switch, a new screen pops up. The
lamp of the READY ( ) key and the lamp of Knife
On/Off( ) key are turned on together.
⑥ When pressing the READY( ) key, the test end message
appears on the screen. The machine moves back to the original
position, and the screen changes back to the initial test screen.
① Use the UP or DOWN key to select ‘7’ on the initial test screen.
Press ENTER.
② When the test screen appears, press ENTER and it will turn on
the lamp of the READY ( ) key. Pressing ENTER again
turns off the lamp of the READY( ) key.
③ Press the READY( ) key, and the test end message is
displayed on the screen. The machine automatically moves back
to the original position, and the screen changes back to the initial
test screen.
7) Auxiliary output test (Aux. Out Test)
↓
↓
↓
↓
↓
↓
↓
OR
( )
( )