SunStar SPS/E-BH6100 - Make Sub-Setting for down Counter; The Initial Screen for Production Counter Setting

58
3) Make sub-setting for Down Counter
① For sub-setting of Down Counter, choose Group A and then
‘A07 : CntDn’. Press ENTER.
② When a new screen comes up, use ◀(+) and ▶(-) to make
detailed setting for Down Counter.
•Buzz & Key : When the counting is completed, a buzzer
goes off and stand by. When ENTER is pressed, the counter
is reset.
•Key : When the counting is completed, it stands by until
ENTER is pressed. When ENTER is pressed, Down
Counter is reset.
•Buzz : When the counting is completed, a buzzer goes off
and the Down Counter is automatically reset.
③ Press ENTER. A buzzer goes off indicating the completion of
the setup. The screen switches to the parameter Group A
screen.
OR
↓
↓
OR
↓
4) The initial screen for production counter setting
① After the production counter setting is completed, the
production counter screen appears. In case where the Up
Counter is set, the value of P_CNT increases for each sewing.
② In case where the Down Counter is set, press the DOWN key
to choose P_CNT and set the counter value by using
◀(+) and
▶(-) keys. For each sewing, the number will be counted
down.
↓
↓
OR
↓
When the production counter is set, turn off the power and turn it on again to apply the setting before
using the counter setting.
Caution