23
1) Change the pattern data information and the initial screen
6-2) Change the pattern data information
① Select DATAINFO by pressing the DOWN key six times, while
the READY lamp is off.
② Press ENTER and it moves to the initial screen for changing
parameter information.
◀Note▶
When the screen is shifted, No. 1 flickers.
③ Press the UP, DOWN keys, and choose [HOME] or [RETURN]
to return to the initial display.
◀Note▶
When the knife on/off key is pressed, the initial screen
appears.
④ Press ENTER and it moves back to the initial display.
2) Change the speed
① Check that the READY lamp is off, and press the DOWN key
to select SPEED.
② Set the desired speed by using ◀(+) and ▶(-).
(ex : 2000rpm)
③ Press ENTER to store the chosen value.
a. Change the speed on the initial display
↓
↓
OR
↓
↓
↓
OR
To Next Page
Loading...
