22
③ The rocking motor is also rotated by 180° in the counterclockwise
direction when pressing the left hand switch at the check mode.
Then it changed into the threading mode.
The sign of ‘Threading’ is blinking on the screen.
④ The rocking motor is stopped after rotating by 180° in the
clockwise direction when pressing the ENTER key and the sign
of ‘Check Mode’ is displayed on the screen.
⑤ When you press the ENTER key again, the feeding base is
moving toward the initial condition and the screen is changed
into the stitching mode.
To Next Page
Loading...
Need help?
General
