53
6-8) Set the chain sewing-related parameters
① Check the READY lamp is off and press the DOWN key five
times. It makes DATAINFO blink. Press ENTER and the
initial parameter setting display appears.
② Select ‘7:Chain’ by using the UP or DOWN key on the screen.
③ Press ENTER. A new screen appears and ‘1: OnOff’ blinks on
the screen. To activate or deactivate the chain sewing function,
select ‘1’ using the UP or DOWN key and press ENTER.
④ It is possible to switch between ‘On’ and ‘Off’ by using ◀(+)
and
▶(-). Set the desired value and press ENTER. Then the
O.K.! message is displayed on the screen.
On : Activate the chain sewing function
Off : Deactivate the chain function (default)
⑤ The screen moves back to the previous screen in one second.
Select ‘2: Set_No’ to set details of the chain sewing function,
and press ENTER.
⑥ When a new screen appears, the details of the chain sewing
function can be set.
⑦ Use the UP or DOWN key to select from 01 to 15. Use ◀(+)
and
▶(-) to insert the already made pattern numbers.
(ex : 0005)
⑧ When the chain sewing setting is completed, press ENTER and
it goes back to the initial sewing setting display.
◀Note▶
To set the chain sewing, parameters should be set up
in advance for the concerned patterns.
↓
OR
↓
↓
OR
↓
OR
↓
↓
↓
↓
OR
↓
OR
↓
↓
↓
OR
↓
↓
1) Enable the chain sewing function
To Next Page
Loading...
