52
◀Note▶ Example of the X direction compensation in the square bartack
[ + direction: Right side] [ - direction: Left side]
◀Note▶ Example of the Y direction compensation in the square bartack
•When the Y-direction compensation takes place in case where the
overlap amount is no bigger than 2.0[mm],
the length of square pattern equals
= basic width + overlap amount - Y-direction compensation value
Therefore, take a caution during setting since the overlap amount
could be reduced.
•When the Y-direction compensation takes place in case where the
overlap amount is 2.0[mm],
the length of square pattern equals
= basic width + overlap amount + Y-direction compensation value
Therefore, the square pattern might get longer. Take a caution
when cutting since the square pattern can be cut off.
Length of
square
pattern
Overlap amount
Length of
square
pattern
Overlap amount
To Next Page
Loading...
