64
① Use the UP or DOWN key and select ‘1’ on the initial test
screen. Press ENTER.
② When a new screen appears, use the◀(+) and ▶(-) keys to test
the X Step motor. Use the
▲(Up) and ▼(Down) keys to test
the Y Step motor. Use the knife On/Off key ( ) and the
clamp Up/Down key ( ) to test the PF Step motor.
③ When the ◀(+) key is pressed, the X step motor test screen
appears.
④ When the ▶(-) key is pressed, a new screen appears and the X
Step motor can be tested.
⑤ When the ▲(Up) key is pressed, a new screen appears and the
Y Step motor can be tested.
⑥ When the ▼(Down) key is pressed, a new screen appears and
the Y Step motor can be tested.
⑦ When the knife On/Off key ( ) is pressed, a new screen
appears and the PF Step motor can be tested (clamp up
direction).
⑧ When the clamp Up/Down key ( ) is pressed, a new
screen appears and the PF Step motor can be tested (clamp
down direction).
⑨ When the READY( ) key is pressed, the testing is over,
and the machine moves to the original position. The screen
switches to the initial testing screen.
1) Step motor test(Jog X, Y, Z Test)
※
When the X step motor is being tested by using the
◀
(+) and
▶
(-) keys, if the original point is passed, the is turned on.
※
When the Y step motor is being tested by using the
▲
(Up) and
▼
(Down) keys, if the original point is passed, the is turned on.
※
When the PF motor is being tested by using the and keys, if the original point is passed, the is turned on.
↓
↓
↓
↓
↓
↓
↓
↓
OR
To Next Page
Loading...
