SunStar SPS/E-BH6100 - Up Bartack Shape Creation

27
1) Create the up bartack shape
⑤ Choose ‘1’ using the UP, DOWN keys and press ENTER.
ex) 1: Up Bar
⑥ The creation of the up bartack shape requires the entry of the
number of eyelet stitches, the knife space in the Y direction and
the knife space in the X direction. First of all, press ENTER to
change the number of eyelet stitches.
⑦ Set the desired value using ◀(+) and ▶(-), and press ENTER.
Then O.K.! message pops up on the screen.
(ex : 0009)
⑧ The screen automatically returns to the previous screen in one
second. Use the DOWN key to set the knife space in the Y
direction. Select ‘2’ and press ENTER.
⑧ Set the desired value using ◀(+) and ▶(-), and press ENTER.
Then O.K.! message pops up on the screen.
(ex : 0000)
⑩ The screen automatically returns to the previous screen in one
second. In order to set the knife space in the X direction, use the
DOWN key, choose ‘3’ and press ENTER.
⑪ Set the desired value using ◀(+) and ▶(-), and press ENTER.
Then O.K.! message pops up on the screen.
(ex : 1)
⑫ The screen automatically returns to the previous screen in one
second. Use the DOWN key to choose [RETURN] and press
ENTER.
◀Note▶
When READY is pressed, all changed parameter values
are saved in the memory. The initial sewing screen
appears.
⑬ The screen for creating the up bartack, the down bartack and the
zigzag pattern appears.
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
OR
↓
↓
↓