39
[Display in case of other patterns (except for eyelet)]
2) Create the pattern data
① Press ENTER and the initial parameter setting screen appears.
② Select [HOME] or [RETURN] using UP or DOWN.
③ Press ENTER to create patterns using changed parameter data.
④ When a new pattern creation is complete, the display
automatically returns to the initial screen.
OR
↓
[Display in case of eyelet shape pattern]
•
In case of eyelet shape pattern, the inside radius information (HOLE) is displayed instead of the
length information (LENG.). When making changes, take this into consideration.
•
When making eyelet shape pattern, install dedicated hammer, cutter, needle plate and clamp for
sewing. Otherwise, some interruption might occur, damaging needles and instruments.
Caution
To Next Page
Loading...
