SunStar SPS/E-BH6100 - 6-11) Use of Upper Thread Nipper Device (Optional)

59
6-11) Setting method of upper thread holder device usage
① Turn on the power while pressing the LEFT key and the clamp
Up/Down key simultaneously. You can see ‘1’ blink on the
screen. Select Group A and press ENTER to use the upper
thread nipper device.
② When a new screen appears, use the DOWN key to select ‘A13
: NIP_D’ and press ENTER.
③ When a new screen appears, use ◀(+) and ▶(-) to select or
cancel the upper thread nipper device.
•Select : Enable
•Cancel: Disable
④ Press ENTER and you can hear a “beep” sound, which
indicates the completion of the setting. The screen returns to
the Parameter A Group screen.
+
↓
↓
↓
↓
OR
↓
+
“Power On”
•upper thread holder device can be used only in the BH6100 -0.1, -0.2 model.
Caution