SunStar SPS/E-BH6100 - Set Knife-Related Parameters; Number of Knives Setting

40
1) Set the number of knives
6-4) Set the knife-related parameters
① Make sure that the READY lamp is off, and press the
DOWN key five times. Then DATAINFO flickers. Press
ENTER, and the initial screen for parameter setting appears.
② Select ‘3’ by pressing the UP or DOWN key.
③ Press ENTER. A new screen pops up and ‘1’ blinks. Select ‘1’
using the UP or DOWN key and press ENTER to set the eyelet
shape.
◀Note▶
‘ 5 : CP Type’is displayed only for BH6100-02 model.
④ Set the desired value using ◀(+) and ▶(-), and enter ENTER.
Then O.K.! message is displayed.
(default : 0002)
↓
↓
OR
↓
↓
↓
OR
↓
OR
↓
◀Note▶ Cutting space according to knife number
Knife no.
When cutting before
sewing (X
××
Y)
Cutting Space
(X
′′××
Y
′′
)
When cutting after
sewing (X
××
Y)
1
1.7 × 2.7 2.1 × 3.2 2.5 × 3.8
2
2.4 × 3.8 2.8 × 4.3 3.2 × 4.9
3
2.6 × 4.1 3.0 × 4.6 3.4 × 5.2
4
2.8 × 4.9 3.2 × 5.4 3.6 × 6.0
5 Straight Straight Straight
6
3.4 × 3.8 3.8 × 4.3 4.2 × 4.9