6-4) Set the knife-related parameters .......................................................................................................................... 40
1) Set the number of knives ............................................................................................................................. 40
2) Set the left/right space for knife .................................................................................................................. 41
3) Blade Motion Method Setting ..................................................................................................................... 42
4-1) Blade Position Setting (When the blade motion method is set at‘Sensor’) ......................................... 43
4-2) Blade Position Setting (When the blade motion method is set at ‘Timing’) ....................................... 44
5) Clamp type (sewing size) setting ............................................................................................................... 45
6-5) Compensation of the eyelet part .................................................................................................................................. 46
6-6) Compensation of the zigzag part.................................................................................................................................. 49
6-7) Lower bar tack correction ............................................................................................................................................ 51
6-8) Set the chain sewing-related parameters...................................................................................................................... 53
1) Enable the chain sewing function............................................................................................................................ 53
2) Use the set chain sewing function ........................................................................................................................... 54
3) Disable the chain sewing function........................................................................................................................... 55
6-9) Set the Back-Tack function........................................................................................................................................... 56
6-10) Set the production counter.......................................................................................................................................... 57
1) Enable/Disable the production counter .................................................................................................................. 57
2) Select the production counter (Up or Down Counter) ........................................................................................... 57
3) Make sub-setting for down counter......................................................................................................................... 58
4) The initial screen for production counter setting ................................................................................................... 58
6-11) Use of upper thread nipper device (optional)............................................................................................................ 59
6-12) Changing the sewing start position .......................................................................................................................... 60
6-13) Set the pattern number ‘0’ .......................................................................................................................................... 61
1) Original setting.......................................................................................................................................................... 61
2) Initialize the pattern-related parameter defaults ..................................................................................................... 62
6-14) Initialization................................................................................................................................................................. 63
6-15) Machine testing functions .......................................................................................................................................... 63
1) Step motor test (Jog X, Y, Z Test)............................................................................................................................ 64
2) Thread tension solenoid test (Sol Test).................................................................................................................... 65
3) Main motor test (M Motor Test) ............................................................................................................................. 66
4) Encoder test ............................................................................................................................................................. 66
5) Synchro test............................................................................................................................................................... 67
6) Hand switch input test.............................................................................................................................................. 67
7) Auxiliary output test(Aux. Out Test)....................................................................................................................... 68
8) Auxiliary input test(Aux. In Test)............................................................................................................................ 69
7. Exchanging the Program ROM.............................................................................................. 70
7-1) Program ROM Mounting Exchanging........................................................................................................................ 70
7-2) Exactly necessary operation after exchanged the program ROM ............................................................................. 71
8. Error Messages and Troubleshooting ........................................................................ 73
9. Parameter Changing Methods and Classification........................................................ 74
9-1) Parameter numbers related to general sewing (Group A).......................................................................................... 74
9-2) Function numbers related to servo motor control (Group B)..................................................................................... 75
To Next Page
Loading...
Need help?
General
