7
SPS/E-BH6100 Series is an industrial sewing machine designed to conduct pattern sewing
using fabrics and other similar materials. During operation, the following instructions should
be kept in mind.
ⓐ Read through this manual carefully and completely before operating the machine.
ⓑ Wear the proper clothes for safety.
ⓒ Keep hands or other parts of the body away from the machine’s operating section
(needle, hook, thread take-up, and pulley, etc.), when the machine is operation.
ⓓ Do not remove safety plates and various covers while the machine is operating.
ⓔ Be sure to connect the grounding conductor.
ⓕ Turn off the machine before opening the electric boxes including control box. Make sure
that the power switch is “OFF”.
ⓖ Stop the machine when placing the thread or when checking the sewing materials.
ⓗ Do not turn on the machine while stepping on the pedal.
ⓘ Do not operate the machine when the cooling pan is clogged. The air filter in the control
box should be cleaned once every week.
ⓙ If possible, install the machine away from the place where powerful electromagnetic
waves are generated such as high-frequency welding machine.
Warning
Caution mark is attached on the machine for safety.
When operating the machine, please read the instructions on the mark.
Locations of caution marks(see the front)
1-5) Locations of
caution marks
1-4) Operation
Control Box
Make sure of closing the covers during operation. Otherwise, fingers or
hands could be broken or get amputated by the belt. When checking or
adjusting the machine, please switch off the machine.
Warning
To Next Page
Loading...
Need help?
General
