SunStar SPS/E-BH6100 - Adjusting Eyelet X-Position and Slant

47
⑨ When a new screen opens, ‘3’ blinks. To set the adjustment
value for the eyelet's position in the X direction, use the UP and
Down keys to select ‘4’ and press the Enter key.
⑩ When a new screen opens, use ◀(+) or ▶(-) to set a desired
value and press the Enter key. Then O.K. is displayed on the
screen.
+ direction : The right-side slant width of eyelet grows larger.
- direction: The right-side slant width of eyelet grows smaller.
⑪ A new screen appears, and ‘4’ blinks. Use the UP or DOWN
keys to set the adjustment value for eyelet in the X direction.
Select ‘5’ and press the Enter key.
⑫ When a new screen appears, use ◀(+) or ▶(-) to set a desired
value. Press the Enter key and O.K. is displayed on the screen.
+ direction : The right-side slant width of eyelet grows larger.
- direction: The left-side slant width of eyelet grows smaller.
OR
OR
↓
↓
↓
↓
↓
↓
↓
↓
↓
◀Example▶
[Rotation Adjustment]
•+ direction: The angle of eyelet increases by the set value
• - direction: The angle of eyelet decreases by the set value
[Radius Adjustment]
•+ direction: The radius of eyelet increases by the set value
•- direction: The radius of eyelet decreases by the set value