1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-84
Port Settings
Clicking the PORT SETTINGS tab brings up the PORT STATUS CONFIGURATION page
(Figure 5-68), which allows you to set the configuration per port related to RSTP. The
parameters for this page are shown in Table 5-52.
Hello Time
This parameter specifies administrative value of hello time for the port. Hello time
may be 1 or 2 seconds. The default value is 2.
Forward Delay
This parameter specifies how fast a port changes its spanning state when
moving towards the Forwarding state. Forwarding time values from 4 to 30
seconds. The default value is 15.
Figure 5-68. Port Status Configuration Page
Table 5-52. Port Status Configuration Page Parameters
Parameter Description
Port This parameter specifies the port identifier.
Port Role
This parameter enables or disables the RSTP protocol status on a particular
port.
Port Priority
This parameter specifies the port priority used in role selection. Port priority
values from 0 to 240. The default priority value is 128.
RSTP Status
This parameter specifies the RSTP protocol status that can be enabled/disabled
on the particular port.
Table 5-51. RSTP Configuration Page Parameters (Continued)
Parameter Description
To Next Page
Loading...
