5-85
Chapter 5: Web Based Management Utility
Port Status
Clicking the PORT STATUS tab brings up the RSTP PORT STATUS page (Figure 5-69),
which displays RSTP port specific information. The parameters for this page are shown
in Table 5-53.
Path Cost
This parameter specifies the path cost associated with this port. Path Cost
values range from 0 to 200000000. The default path cost is calculated based on
the port speed.
Protocol Migration
This parameter controls the migration from RSTP to STP, if the other side of the
switch runs STP. The migration takes place only if this is Enabled.
AdminEdge Port This parameter defines this port as an Edge Port or a Non-edge Port.
Admin Point-to-Point
This parameter allows you to configure ports explicitly as Point-to-point (Force
true), Non-point-to-point or leave the decision to be made Dynamically (from the
AL or MAC layer).
Auto Edge Detection If this parameter is set to True, the edge port status is dynamically calculated.
Restricted Role This parameter specifies the RESTRICTED ROLE status of the port.
Restricted TCN This parameter indicates the RESTRICTED TCN status of the port.
Figure 5-69. RSTP Port Status Page
Table 5-52. Port Status Configuration Page Parameters (Continued)
Parameter Description
To Next Page
Loading...
